Change to build_dir/linux-kirkwood/linux-2.6.30.10 and apply the following patch: Please note that for HDTV (1080i/720p) with Linux an optimized PC system should be used, in order to minimize the CPU. (This step isn't required, but I recommend it for easier recovery from bad flash writes below.) Use "make kernel_menuconfig" to add built-in SCSI disk, USB EHCI, USB storage, and ext2 filesystem support.ģ. Also select built-in luci and ntpclient packages. Add squashfs in the target images section. Use "make menuconfig" to configure the build system for a kirkwood target. You need to build your own OpenWrt kernel and root filesystem image, because the Marvell Kirkwood target currently supports only the Sheevaplug, which has a different NAND flash layout.
SEAGATE DOCKSTAR MANUAL HOW TO
See this page for the serial pinout (and how to open the case) and this page for a picture of where to find the connector.Ģ.
SEAGATE DOCKSTAR MANUAL INSTALL
Open the case and install a serial cable. No one has tried to restore the factory firmware yet, so we don't know whether that's possible. Creme de Cacao - rootDockStar: / netstat -nr Kernel IP routing table Destination. A handful of 2.0mm female connectors or one 2.0mm female connector with at least 10 pins (5 pins in 2 rows) A 10 pin header that matches your PCB 2. On my Seagate DockStar flashed with a self-built firmware, netstat is included in the busybox as shown below. Run Linux on your Dockstar, GoFlex, or Pogoplug NAS Seagate GoFlex Home Seagate.
WARNING: this approach requires you to open the case and install a serial cable, and completely replaces the factory-installed software with OpenWrt. The dead seagate dockstar and power supply. Seagate Redstone EHDUL2 REV C printed on bottom of board. could read this page: Alternative operating systems for the Seagate Dockstar. Update: I've consolidated this HOWTO and the following one into a single guide to installing OpenWrt on the Dockstar. Ca for part finder, operator manuals, or to chat with a Customer Support. This post describes how to install an OpenWrt kernel and rootfs on the internal NAND flash of the Seagate Dockstar so that it will boot into OpenWrt at power-on, with no USB storage device required.
0 kommentar(er)
